Home/X1E/Overture/PETG
Overture · overlaid on Bambu's PETG Basic

Overture PETG for the X1E

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Overture PETG spool — the big one first.

Bambu profiles its own filament, not Overture's. These start from Bambu's PETG Basic reference and apply Overture's published specs where available.
Max volumetric flowupdates live
18 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
214mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.045
starting point — refine on-machine
Flow ratio
0.95
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 18 mm³/s · Bambu default — Overture publishes none ⚠ clamped — capped below your target speed
Overture · PETG Basic tds
Nozzle245 °C
Density1.3 g/cm³
Drying60 °C / 5 h
Mfr speed≤300 mm/s
Mfr bed65–70 °C
TDS V5.2: density 1.30; Vicat ~85 °C; over-drying causes brittleness
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.95 · ceiling 18 mm³/s
Source
tds · manufacturer ↗

Why these numbers

Overture PETG starts from Bambu's PETG Basic reference; Overture's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

TDS V5.2: density 1.30; Vicat ~85 °C; over-drying causes brittleness

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Overture PETG profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Overture PETG for the X1 Carbon
/p/x1c/overture/petg
Overture PETG for the A1
/p/a1/overture/petg
Overture PETG for the A1 mini
/p/a1_mini/overture/petg
3D-Fuel Pro PETG for the X1E
/p/x1e/3d-fuel/pro-petg
Amazon Basics PETG Filament 1.75 mm for the X1E
/p/x1e/amazon-basics/petg-filament-1-75-mm
Amazon Basics PETG Filament 2.85 mm for the X1E
/p/x1e/amazon-basics/petg-filament-2-85-mm