Home/X1E/Eryone/Standard PETG
Eryone · overlaid on Bambu's PETG Basic

Eryone Standard PETG for the X1E

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Eryone Standard PETG spool — the big one first.

Bambu profiles its own filament, not Eryone's. These start from Bambu's PETG Basic reference and apply Eryone's published specs where available.
Max volumetric flowupdates live
6.72 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
80mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.045
starting point — refine on-machine
Flow ratio
0.95
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 18 mm³/s · Bambu default — Eryone publishes none ⚠ clamped — capped below your target speed
Eryone · Standard PETG Basic tds
Nozzle240 °C
Density1.25 g/cm³
Drying80 °C / 12 h
Mfr speed30–80 mm/s
Mfr bed75–80 °C
Open or enclosed; water/weather resistant
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.95 · ceiling 18 mm³/s
Source
tds · manufacturer ↗

Why these numbers

Eryone Standard PETG starts from Bambu's PETG Basic reference; Eryone's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Open or enclosed; water/weather resistant

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Eryone Standard PETG profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Eryone Standard PETG for the X1 Carbon
/p/x1c/eryone/standard-petg
Eryone Standard PETG for the A1
/p/a1/eryone/standard-petg
Eryone Standard PETG for the A1 mini
/p/a1_mini/eryone/standard-petg
3D-Fuel Pro PETG for the X1E
/p/x1e/3d-fuel/pro-petg
Amazon Basics PETG Filament 1.75 mm for the X1E
/p/x1e/amazon-basics/petg-filament-1-75-mm
Amazon Basics PETG Filament 2.85 mm for the X1E
/p/x1e/amazon-basics/petg-filament-2-85-mm