Home/X1 Carbon/JAYO/PLA Meta
JAYO · overlaid on Bambu's PLA Basic

JAYO PLA Meta for the X1 Carbon

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a JAYO PLA Meta spool — the big one first.

Bambu profiles its own filament, not JAYO's. These start from Bambu's PLA Basic reference and apply JAYO's published specs where available.
Max volumetric flowupdates live
12.6 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
150mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.02
starting point — refine on-machine
Flow ratio
0.98
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 21 mm³/s · Bambu default — JAYO publishes none ⚠ clamped — capped below your target speed
JAYO · PLA Meta High-speed / low-temp product page
Nozzle190 °C
Density1.23 g/cm³
Mfr speed50–150 mm/s
Mfr bed50–60 °C
TDS: density 1.23; lower print temp than std PLA; speed envelope 50–150 mm/s
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.98 · ceiling 21 mm³/s
Source
product page · manufacturer ↗

Why these numbers

JAYO PLA Meta starts from Bambu's PLA Basic reference; JAYO's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

TDS: density 1.23; lower print temp than std PLA; speed envelope 50–150 mm/s

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the JAYO PLA Meta profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

JAYO PLA Meta for the A1
/p/a1/jayo/pla-meta
JAYO PLA Meta for the A1 mini
/p/a1_mini/jayo/pla-meta
JAYO PLA Meta for the P1S
/p/p1s/jayo/pla-meta
3D-Fuel Tough Pro PLA+ for the X1 Carbon
/p/x1c/3d-fuel/tough-pro-pla
Amazon Basics PLA Filament 1.75 mm for the X1 Carbon
/p/x1c/amazon-basics/pla-filament-1-75-mm
Amazon Basics PLA Filament 1.75 mm (1.25 kg) for the X1 Carbon
/p/x1c/amazon-basics/pla-filament-1-75-mm-1-25-kg