Home/P2S/eSUN/PETG-Matte
eSUN · overlaid on Bambu's PETG Basic

eSUN PETG-Matte for the P2S

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a eSUN PETG-Matte spool — the big one first.

Bambu profiles its own filament, not eSUN's. These start from Bambu's PETG Basic reference and apply eSUN's published specs where available.
Max volumetric flowupdates live
15 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
179mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.045
starting point — refine on-machine
Flow ratio
0.92
eSUN’s published value
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 15 mm³/s · Bambu default — eSUN publishes none ⚠ clamped — capped below your target speed
eSUN · PETG-Matte Matte profile zip
Nozzle260 °C
Densitynot published
Mfr speednot published
Mfr bed65 °C
Inherits PETG Basic @BBL A1; flow 0.92; lower bed
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

!
P2S values are provisional
These envelope/flow values still need verifying against Bambu's shipped profile (SPEC.md §10).
Against Bambu stock
flow 0.92 · ceiling 15 mm³/s
Source
profile zip · manufacturer ↗

Why these numbers

eSUN PETG-Matte starts from Bambu's PETG Basic reference; eSUN's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Inherits PETG Basic @BBL A1; flow 0.92; lower bed

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the eSUN PETG-Matte profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

eSUN PETG-Matte for the X1 Carbon
/p/x1c/esun/petg-matte
eSUN PETG-Matte for the A1
/p/a1/esun/petg-matte
eSUN PETG-Matte for the A1 mini
/p/a1_mini/esun/petg-matte
3D-Fuel Pro PETG for the P2S
/p/p2s/3d-fuel/pro-petg
Amazon Basics PETG Filament 1.75 mm for the P2S
/p/p2s/amazon-basics/petg-filament-1-75-mm
Amazon Basics PETG Filament 2.85 mm for the P2S
/p/p2s/amazon-basics/petg-filament-2-85-mm