Max volumetric flowupdates live

5.04 mm³/s The single value Bambu Studio can’t guess for you

Effective top speed

60mm/s

you asked for 300

target 300 → clamped

Pressure advance K

0.02

starting point — refine on-machine

Flow ratio

0.98

Bambu base (inherited)

Retraction length

0.8mm

Bambu base (inherited)

hotend ceiling 21 mm³/s · Bambu default — Eryone publishes none ⚠ clamped — capped below your target speed

Eryone · Galaxy PLA Sparkle tds

Nozzle205 °C

Density1.23 g/cm³

Drying65–75 °C / 12 h

Mfr speed30–60 mm/s

Mfr bed55–70 °C

Sparkle particles; cap speed at 60 mm/s; hardened nozzle recommended

manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

A hardened nozzle is recommended

Eryone Galaxy PLA is mildly abrasive — it'll wear a stainless nozzle over time. It still prints fine on stainless; switch hardness to Hardened for longevity.

Against Bambu stock

flow 0.98 · ceiling 21 mm³/s

Source

tds · manufacturer ↗

Why these numbers

Eryone Galaxy PLA starts from Bambu's PLA Basic reference; Eryone's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Sparkle particles; cap speed at 60 mm/s; hardened nozzle recommended

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Eryone Galaxy PLA profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.