Home/P1S/Elegoo/PLA Matte
Elegoo · overlaid on Bambu's PLA Basic

Elegoo PLA Matte for the P1S

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Elegoo PLA Matte spool — the big one first.

Bambu profiles its own filament, not Elegoo's. These start from Bambu's PLA Basic reference and apply Elegoo's published specs where available.
Max volumetric flowupdates live
21 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
250mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.02
starting point — refine on-machine
Flow ratio
0.98
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 21 mm³/s · Bambu default — Elegoo publishes none ⚠ clamped — capped below your target speed
Elegoo · PLA Matte Matte product page
Nozzle210 °C
Density1.26 g/cm³
Drying50 ±5 °C / 8 h
Mfr speed≤300 mm/s
Mfr bed35–65 °C
Tensile X-Y 30 MPa (lower than std PLA); Vicat 63 °C
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.98 · ceiling 21 mm³/s
Source
product page · manufacturer ↗

Why these numbers

Elegoo PLA Matte starts from Bambu's PLA Basic reference; Elegoo's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Tensile X-Y 30 MPa (lower than std PLA); Vicat 63 °C

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Elegoo PLA Matte profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Elegoo PLA Matte for the X1 Carbon
/p/x1c/elegoo/pla-matte
Elegoo PLA Matte for the A1
/p/a1/elegoo/pla-matte
Elegoo PLA Matte for the A1 mini
/p/a1_mini/elegoo/pla-matte
3D-Fuel Tough Pro PLA+ for the P1S
/p/p1s/3d-fuel/tough-pro-pla
Amazon Basics PLA Filament 1.75 mm for the P1S
/p/p1s/amazon-basics/pla-filament-1-75-mm
Amazon Basics PLA Filament 1.75 mm (1.25 kg) for the P1S
/p/p1s/amazon-basics/pla-filament-1-75-mm-1-25-kg