Home/P1P/FlashForge/PLA Pro
FlashForge · overlaid on Bambu's PLA Basic

FlashForge PLA Pro for the P1P

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a FlashForge PLA Pro spool — the big one first.

Bambu profiles its own filament, not FlashForge's. These start from Bambu's PLA Basic reference and apply FlashForge's published specs where available.
Max volumetric flowupdates live
5.04 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
60mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.02
starting point — refine on-machine
Flow ratio
0.98
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 21 mm³/s · Bambu default — FlashForge publishes none ⚠ clamped — capped below your target speed
FlashForge · PLA Pro Tough tds
Nozzle205 °C
Densitynot published
Mfr speed40–60 mm/s
Mfr bed25–60 °C
Tensile 45.5–49 MPa; flexural 73–76 MPa; water absorption <0.3%
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.98 · ceiling 21 mm³/s
Source
tds · manufacturer ↗

Why these numbers

FlashForge PLA Pro starts from Bambu's PLA Basic reference; FlashForge's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Tensile 45.5–49 MPa; flexural 73–76 MPa; water absorption <0.3%

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the FlashForge PLA Pro profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

FlashForge PLA Pro for the X1 Carbon
/p/x1c/flashforge/pla-pro
FlashForge PLA Pro for the A1
/p/a1/flashforge/pla-pro
FlashForge PLA Pro for the A1 mini
/p/a1_mini/flashforge/pla-pro
3D-Fuel Tough Pro PLA+ for the P1P
/p/p1p/3d-fuel/tough-pro-pla
Amazon Basics PLA Filament 1.75 mm for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm
Amazon Basics PLA Filament 1.75 mm (1.25 kg) for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm-1-25-kg