Home/P1P/Eryone/Glow in the Dark PLA
Eryone · overlaid on Bambu's PLA Basic

Eryone Glow in the Dark PLA for the P1P

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Eryone Glow in the Dark PLA spool — the big one first.

Bambu profiles its own filament, not Eryone's. These start from Bambu's PLA Basic reference and apply Eryone's published specs where available.
Max volumetric flowupdates live
21 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
250mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.02
starting point — refine on-machine
Flow ratio
0.98
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 21 mm³/s · Bambu default — Eryone publishes none ⚠ clamped — capped below your target speed
Eryone · Glow in the Dark PLA Glow tds
Nozzle200 °C
Density1.25 g/cm³
Drying65–75 °C / 12 h
Mfr speed30–500 mm/s
Mfr bed55–70 °C
Phosphorescent; hardened nozzle recommended
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.98 · ceiling 21 mm³/s
Source
tds · manufacturer ↗

Why these numbers

Eryone Glow in the Dark PLA starts from Bambu's PLA Basic reference; Eryone's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Phosphorescent; hardened nozzle recommended

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Eryone Glow in the Dark PLA profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Eryone Glow in the Dark PLA for the X1 Carbon
/p/x1c/eryone/glow-in-the-dark-pla
Eryone Glow in the Dark PLA for the A1
/p/a1/eryone/glow-in-the-dark-pla
Eryone Glow in the Dark PLA for the A1 mini
/p/a1_mini/eryone/glow-in-the-dark-pla
3D-Fuel Tough Pro PLA+ for the P1P
/p/p1p/3d-fuel/tough-pro-pla
Amazon Basics PLA Filament 1.75 mm for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm
Amazon Basics PLA Filament 1.75 mm (1.25 kg) for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm-1-25-kg