Home/P1P/Elegoo/PLA Silk
Elegoo · overlaid on Bambu's PLA Basic

Elegoo PLA Silk for the P1P

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Elegoo PLA Silk spool — the big one first.

Bambu profiles its own filament, not Elegoo's. These start from Bambu's PLA Basic reference and apply Elegoo's published specs where available.
Max volumetric flowupdates live
18.48 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
220mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.02
starting point — refine on-machine
Flow ratio
0.98
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 21 mm³/s · Bambu default — Elegoo publishes none ⚠ clamped — capped below your target speed
Elegoo · PLA Silk Silk product page
Nozzle210 °C
Density1.25 g/cm³
Drying50 ±5 °C / 8 h (REQUIRED)
Mfr speed≤220 mm/s
Mfr bed35–65 °C
Hardened steel nozzle, ≥0.4 mm; melt index 28.7 (3× std PLA); tensile X-Y 26 MPa, Z just 5 MPa (anisotropic)
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.98 · ceiling 21 mm³/s
Source
product page · manufacturer ↗

Why these numbers

Elegoo PLA Silk starts from Bambu's PLA Basic reference; Elegoo's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Hardened steel nozzle, ≥0.4 mm; melt index 28.7 (3× std PLA); tensile X-Y 26 MPa, Z just 5 MPa (anisotropic)

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Elegoo PLA Silk profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Elegoo PLA Silk for the X1 Carbon
/p/x1c/elegoo/pla-silk
Elegoo PLA Silk for the A1
/p/a1/elegoo/pla-silk
Elegoo PLA Silk for the A1 mini
/p/a1_mini/elegoo/pla-silk
3D-Fuel Tough Pro PLA+ for the P1P
/p/p1p/3d-fuel/tough-pro-pla
Amazon Basics PLA Filament 1.75 mm for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm
Amazon Basics PLA Filament 1.75 mm (1.25 kg) for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm-1-25-kg