Home/P1P/Elegoo/PLA (RFID / standard)
Elegoo · overlaid on Bambu's PLA Basic

Elegoo PLA (RFID / standard) for the P1P

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Elegoo PLA (RFID / standard) spool — the big one first.

Bambu profiles its own filament, not Elegoo's. These start from Bambu's PLA Basic reference and apply Elegoo's published specs where available.
Max volumetric flowupdates live
21 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
250mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.02
starting point — refine on-machine
Flow ratio
0.98
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 21 mm³/s · Bambu default — Elegoo publishes none ⚠ clamped — capped below your target speed
Elegoo · PLA (RFID / standard) Basic product page
Nozzle210 °C
Density1.26 g/cm³
Drying50 ±5 °C / 8 h
Mfr speed≤300 mm/s
Mfr bed35–65 °C
Chamber 20–45 °C; tensile X-Y 38 MPa, Z 23 MPa; HDT 57 °C; RFID smart-tag variant available (Elegoo CANVAS slicer auto-identifies)
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.98 · ceiling 21 mm³/s
Source
product page · manufacturer ↗

Why these numbers

Elegoo PLA (RFID / standard) starts from Bambu's PLA Basic reference; Elegoo's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Chamber 20–45 °C; tensile X-Y 38 MPa, Z 23 MPa; HDT 57 °C; RFID smart-tag variant available (Elegoo CANVAS slicer auto-identifies)

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Elegoo PLA (RFID / standard) profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Elegoo PLA (RFID / standard) for the X1 Carbon
/p/x1c/elegoo/pla-rfid-standard
Elegoo PLA (RFID / standard) for the A1
/p/a1/elegoo/pla-rfid-standard
Elegoo PLA (RFID / standard) for the A1 mini
/p/a1_mini/elegoo/pla-rfid-standard
3D-Fuel Tough Pro PLA+ for the P1P
/p/p1p/3d-fuel/tough-pro-pla
Amazon Basics PLA Filament 1.75 mm for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm
Amazon Basics PLA Filament 1.75 mm (1.25 kg) for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm-1-25-kg