Home/P1P/Elegoo/PLA Pro
Elegoo · overlaid on Bambu's PLA Basic

Elegoo PLA Pro for the P1P

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Elegoo PLA Pro spool — the big one first.

Bambu profiles its own filament, not Elegoo's. These start from Bambu's PLA Basic reference and apply Elegoo's published specs where available.
Max volumetric flowupdates live
21 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
250mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.02
starting point — refine on-machine
Flow ratio
0.98
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 21 mm³/s · Bambu default — Elegoo publishes none ⚠ clamped — capped below your target speed
Elegoo · PLA Pro Engineering product page
Nozzle195 °C
Density1.24 g/cm³
Drying50 ±5 °C / 8 h
Mfr speed≤300 mm/s
Mfr bed35–65 °C
Lowest nozzle range of any Elegoo PLA; "better temperature resistance"; tensile X-Y 32 MPa; HDT 56 °C
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.98 · ceiling 21 mm³/s
Source
product page · manufacturer ↗

Why these numbers

Elegoo PLA Pro starts from Bambu's PLA Basic reference; Elegoo's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Lowest nozzle range of any Elegoo PLA; "better temperature resistance"; tensile X-Y 32 MPa; HDT 56 °C

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Elegoo PLA Pro profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Elegoo PLA Pro for the X1 Carbon
/p/x1c/elegoo/pla-pro
Elegoo PLA Pro for the A1
/p/a1/elegoo/pla-pro
Elegoo PLA Pro for the A1 mini
/p/a1_mini/elegoo/pla-pro
3D-Fuel Tough Pro PLA+ for the P1P
/p/p1p/3d-fuel/tough-pro-pla
Amazon Basics PLA Filament 1.75 mm for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm
Amazon Basics PLA Filament 1.75 mm (1.25 kg) for the P1P
/p/p1p/amazon-basics/pla-filament-1-75-mm-1-25-kg