Home/H2DP/eSUN/High Speed TPU-95A
eSUN · overlaid on Bambu's TPU 95A

eSUN High Speed TPU-95A for the H2DP

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a eSUN High Speed TPU-95A spool — the big one first.

Bambu profiles its own filament, not eSUN's. These start from Bambu's TPU 95A reference and apply eSUN's published specs where available.
Max volumetric flowupdates live
3.6 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
43mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.05
starting point — refine on-machine
Flow ratio
1.05
eSUN’s published value
Retraction length
1.2mm
Bambu base (inherited)
hotend ceiling 3.6 mm³/s · Bambu default — eSUN publishes none ⚠ clamped — capped below your target speed
eSUN · High Speed TPU-95A High-speed flexible tds
Nozzle220 °C
Densitynot published
Mfr speed≤150 mm/s
Mfr bed30–45 °C
Shore95A
From eSUN High Speed Printing Filament Parameters PDF (Bambu P1P/X1): inner-wall/infill ≤150 mm/s (outer wall 80); max vol 5 mm³/s; flow 1.05; retraction 1.5 mm — on Bambu, turn off the material Retraction Length.
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

!
H2DP values are provisional
These envelope/flow values still need verifying against Bambu's shipped profile (SPEC.md §10).
Against Bambu stock
flow 1.05 · ceiling 3.6 mm³/s
Source
tds · manufacturer ↗

Why these numbers

eSUN High Speed TPU-95A starts from Bambu's TPU 95A reference; eSUN's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

From eSUN High Speed Printing Filament Parameters PDF (Bambu P1P/X1): inner-wall/infill ≤150 mm/s (outer wall 80); max vol 5 mm³/s; flow 1.05; retraction 1.5 mm — on Bambu, turn off the material Retraction Length.

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the eSUN High Speed TPU-95A profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

eSUN High Speed TPU-95A for the X1 Carbon
/p/x1c/esun/high-speed-tpu-95a
eSUN High Speed TPU-95A for the A1
/p/a1/esun/high-speed-tpu-95a
eSUN High Speed TPU-95A for the A1 mini
/p/a1_mini/esun/high-speed-tpu-95a
Bambu Lab TPU 95A for the H2DP
/p/h2dp/bambu-lab/tpu-95a
ColorFabb TPU 85A for the H2DP
/p/h2dp/colorfabb/tpu-85a
ColorFabb TPU 95A for the H2DP
/p/h2dp/colorfabb/tpu-95a