Home/H2DP/Elegoo/PETG Pro
Elegoo · overlaid on Bambu's PETG Basic

Elegoo PETG Pro for the H2DP

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Elegoo PETG Pro spool — the big one first.

Bambu profiles its own filament, not Elegoo's. These start from Bambu's PETG Basic reference and apply Elegoo's published specs where available.
Max volumetric flowupdates live
18 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
214mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.045
starting point — refine on-machine
Flow ratio
0.95
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 18 mm³/s · Bambu default — Elegoo publishes none ⚠ clamped — capped below your target speed
Elegoo · PETG Pro Engineering product page
Nozzle245 °C
Density1.27 g/cm³
Drying60 ±5 °C / 8 h (REQUIRED)
Mfr speed≤270 mm/s
Mfr bed65–75 °C
Chamber 25–50 °C; tensile X-Y 40 MPa; HDT 73 °C; Vicat 71 °C; impact 78.5 kJ/m²
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

!
H2DP values are provisional
These envelope/flow values still need verifying against Bambu's shipped profile (SPEC.md §10).
Against Bambu stock
flow 0.95 · ceiling 18 mm³/s
Source
product page · manufacturer ↗

Why these numbers

Elegoo PETG Pro starts from Bambu's PETG Basic reference; Elegoo's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Chamber 25–50 °C; tensile X-Y 40 MPa; HDT 73 °C; Vicat 71 °C; impact 78.5 kJ/m²

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Elegoo PETG Pro profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Elegoo PETG Pro for the X1 Carbon
/p/x1c/elegoo/petg-pro
Elegoo PETG Pro for the A1
/p/a1/elegoo/petg-pro
Elegoo PETG Pro for the A1 mini
/p/a1_mini/elegoo/petg-pro
3D-Fuel Pro PETG for the H2DP
/p/h2dp/3d-fuel/pro-petg
Amazon Basics PETG Filament 1.75 mm for the H2DP
/p/h2dp/amazon-basics/petg-filament-1-75-mm
Amazon Basics PETG Filament 2.85 mm for the H2DP
/p/h2dp/amazon-basics/petg-filament-2-85-mm