Max volumetric flowupdates live

5.04 mm³/s The single value Bambu Studio can’t guess for you

Effective top speed

60mm/s

you asked for 300

target 300 → clamped

Pressure advance K

0.03

starting point — refine on-machine

Flow ratio

0.98

Bambu base (inherited)

Retraction length

0.8mm

Bambu base (inherited)

hotend ceiling 15 mm³/s · Bambu default — JAYO publishes none ⚠ clamped — capped below your target speed

JAYO · PLA Carbon Fiber Carbon-fibre product page

Nozzle220 °C

Density1.2 g/cm³

Mfr speed40–60 mm/s

Mfr bed50–60 °C

TDS: density 1.20; modulus 3530 MPa; hardened nozzle required. PDF title says "PLA Marble" — appears to be a JAYO documentation bug; printing parameters are CF-typical

manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock

flow 0.98 · ceiling 15 mm³/s

Source

product page · manufacturer ↗

Why these numbers

JAYO PLA Carbon Fiber starts from Bambu's PLA-CF reference; JAYO's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

TDS: density 1.20; modulus 3530 MPa; hardened nozzle required. PDF title says "PLA Marble" — appears to be a JAYO documentation bug; printing parameters are CF-typical

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the JAYO PLA Carbon Fiber profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.