Home/H2C/eSUN/PETG / PETG-Basic
eSUN · overlaid on Bambu's PETG Basic

eSUN PETG / PETG-Basic for the H2C

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a eSUN PETG / PETG-Basic spool — the big one first.

Bambu profiles its own filament, not eSUN's. These start from Bambu's PETG Basic reference and apply eSUN's published specs where available.
Max volumetric flowupdates live
18 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
214mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.045
starting point — refine on-machine
Flow ratio
0.92
eSUN’s published value
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 18 mm³/s · Bambu default — eSUN publishes none ⚠ clamped — capped below your target speed
eSUN · PETG / PETG-Basic Basic profile zip
Nozzle255 °C
Density1.27 g/cm³
Mfr speednot published
Mfr bed80 °C
Inherits PETG Basic @BBL A1; flow ratio 0.92 (down from Bambu's 0.95). Density from eSUN PETG TDS V4.0.
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.92 · ceiling 18 mm³/s
Source
profile zip · manufacturer ↗

Why these numbers

eSUN PETG / PETG-Basic starts from Bambu's PETG Basic reference; eSUN's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Inherits PETG Basic @BBL A1; flow ratio 0.92 (down from Bambu's 0.95). Density from eSUN PETG TDS V4.0.

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the eSUN PETG / PETG-Basic profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

eSUN PETG / PETG-Basic for the X1 Carbon
/p/x1c/esun/petg-petg-basic
eSUN PETG / PETG-Basic for the A1
/p/a1/esun/petg-petg-basic
eSUN PETG / PETG-Basic for the A1 mini
/p/a1_mini/esun/petg-petg-basic
3D-Fuel Pro PETG for the H2C
/p/h2c/3d-fuel/pro-petg
Amazon Basics PETG Filament 1.75 mm for the H2C
/p/h2c/amazon-basics/petg-filament-1-75-mm
Amazon Basics PETG Filament 2.85 mm for the H2C
/p/h2c/amazon-basics/petg-filament-2-85-mm