Home/A1/Inland/TPU
Inland · overlaid on Bambu's TPU 95A

Inland TPU for the A1

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Inland TPU spool — the big one first.

Bambu profiles its own filament, not Inland's. These start from Bambu's TPU 95A reference and apply Inland's published specs where available.
Max volumetric flowupdates live
3.6 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
43mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.05
starting point — refine on-machine
Flow ratio
1
Bambu base (inherited)
Retraction length
1.2mm
Bambu base (inherited)
hotend ceiling 3.6 mm³/s · Bambu default — Inland publishes none ⚠ clamped — capped below your target speed
Inland · TPU Flexible product page
Nozzle230 °CBambu base · not published
Densitynot published
Mfr speednot published
Shore95A
Standard 95A flexible
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 1 · ceiling 3.6 mm³/s
Source
product page · manufacturer ↗

Why these numbers

Inland TPU starts from Bambu's TPU 95A reference; Inland's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Standard 95A flexible

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Inland TPU profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Inland TPU for the X1 Carbon
/p/x1c/inland/tpu
Inland TPU for the A1 mini
/p/a1_mini/inland/tpu
Inland TPU for the P1S
/p/p1s/inland/tpu
Bambu Lab TPU 95A for the A1
/p/a1/bambu-lab/tpu-95a
ColorFabb TPU 85A for the A1
/p/a1/colorfabb/tpu-85a
ColorFabb TPU 95A for the A1
/p/a1/colorfabb/tpu-95a