Home/A1/Eryone/PLA+
Eryone · overlaid on Bambu's PLA Basic

Eryone PLA+ for the A1

with a 0.4 mm nozzle

The five values to type into Bambu Studio for a Eryone PLA+ spool — the big one first.

Bambu profiles its own filament, not Eryone's. These start from Bambu's PLA Basic reference and apply Eryone's published specs where available.
Max volumetric flowupdates live
8.4 mm³/s The single value Bambu Studio can’t guess for you
Effective top speed
100mm/s
you asked for 300
target 300 → clamped
Pressure advance K
0.02
starting point — refine on-machine
Flow ratio
0.98
Bambu base (inherited)
Retraction length
0.8mm
Bambu base (inherited)
hotend ceiling 21 mm³/s · Bambu default — Eryone publishes none ⚠ clamped — capped below your target speed
Eryone · PLA+ Tough tds
Nozzle205 °C
Density1.23 g/cm³
Drying65–75 °C / 12 h
Mfr speed30–100 mm/s
Mfr bed55–70 °C
Glass / PEI / spring steel; Vicat 54 °C
manufacturer source ↗

Is this right for your spool?

Here's how sure we are — and what to watch.

Against Bambu stock
flow 0.98 · ceiling 21 mm³/s
Source
tds · manufacturer ↗

Why these numbers

Eryone PLA+ starts from Bambu's PLA Basic reference; Eryone's published specs are overlaid where available, and everything else stays at Bambu's calibrated default.

Glass / PEI / spring steel; Vicat 54 °C

Treat these as a starting point — run a flow-test cube and Bambu's Flow Dynamics calibration after import for the last few percent.

Open in the wizard → change printer, nozzle or speed

Download the Eryone PLA+ profile

A .zip with the Bambu Studio .json and a Markdown summary of every field.

Open in the wizard
i
Then calibrate in the slicer. Run Device → Calibration → Flow Dynamics after import to lock in the K-factor.

More combinations

Eryone PLA+ for the X1 Carbon
/p/x1c/eryone/pla
Eryone PLA+ for the A1 mini
/p/a1_mini/eryone/pla
Eryone PLA+ for the P1S
/p/p1s/eryone/pla
3D-Fuel Tough Pro PLA+ for the A1
/p/a1/3d-fuel/tough-pro-pla
Amazon Basics PLA Filament 1.75 mm for the A1
/p/a1/amazon-basics/pla-filament-1-75-mm
Amazon Basics PLA Filament 1.75 mm (1.25 kg) for the A1
/p/a1/amazon-basics/pla-filament-1-75-mm-1-25-kg